Drying Accelerator

G Dryer

■　Features

One component type additive that accelerates oxidative polymerization of oil-based offset inks.
It expedites drying during printing by reacting with water in the dampening solution and releasing oxygen.
Add within 1~ 3%. Adding more than specified amount does not add to effectiveness.
It is ideal for low-absorbent, synthetic and matte coated papers.
In perfect printing it prevents drying defects due to hypoxia in areas where images on both side face each other.
It is free of lead and cobalt. (Contains manganese)
It is not affected by dampening water's pH.

■　Handling Instructions

Not useable for waterless lithographic printing.
Cannot be used for light (simple) offset printing.
Do not apply G Dryer to the front side of synthetic paper in double-sided printing. It causes back ghosting. Use G Dryer for rear side printing.
Pay attention to the drying of ink on the rollers, because the drying is accelerated even in the printing press.
With the passage of time G Dryer's vegetable oil contents can cause skinning by reacting with the oxygen in the air. Even if this occurs, simply remove the film. The performance is unaffected.

★NL Mark: This ink was manufactured in accordance with the "Self-imposed Regulations Regarding Printing Inks" (NL Regulations) enacted by Japan Printing Ink Makers Association.

The data contained herein are based on the results of the tests conducted in accordance with the in-house test methods, and are not standard values. Always conduct pre-use tests to ascertain the suitability of the product to your requirements. Nothing contained herein is to be construed as a recommendation for use in violation of any patents, applicable laws or regulations. It is the responsibility of the user to comply in all respects with applicable laws and regulations.
Owing to product improvement the information contained herein may be modified without any prior notice.
Make sure to read MSDS thoroughly before using the product.